Text from the interactive explanation
Endlessly self-injection-locked photonic integrated lasers
Mikael Reichler, Simone Bianconi, Yichi Zhang, Marco Liffredo, Luis Guillermo Villanueva, Tobias J. Kippenberg
Original paperNature Photonics · 2026 · Reichler, Bianconi, Zhang, Liffredo, Villanueva & Kippenberg
A chip laser locked to a spiral resonator usually loses its grip as its current changes. Move one mirror port a few centimetres around the spiral and it never does.
Live simulation — the authors' published rate-equation model (Supplementary Section I), ported to run in your browser with the parameters of their Fig. 2f–h. Every hop is computed, not animated.
laser line (width ∝ 1/Δν, log-compressed)
Drag the loop mirror around the ring, or use this slider. One trip around turns ΔΨ through two full cycles (Eq. 2: the port enters through 2τR).
Each flat step is the laser held by one resonance; a dotted jump is a hop to another locked state; an orange ramp means it has let go and runs free. Lower the coupling to open gaps between resonances (as in the paper's Fig. 3h); shift the gap to see that a well-placed port does not care.
1 · The problem
A lock that only holds sometimes
Semiconductor lasers are small, cheap and electrically pumped, but their frequency jitters: the distributed-feedback (DFB) laser in this study has a free-running intrinsic linewidth of about 70 kHz. Self-injection locking calms it by sending light back from an ultra-high-Q resonator — here a silicon nitride spiral with an intrinsic quality factor of 11.3 million. The returning light pulls the laser onto the resonance and suppresses its frequency noise by orders of magnitude.
But the lock exists only near particular drive currents. As the current tunes the laser, it slides along the locking plateau until it lets go, runs free, and waits for the next resonance to catch it. Keeping a conventional self-injection-locked laser in its narrow state needs photodetectors, dithering and feedback electronics.
The plot shows stationary solutions of the same model for one resonance. On the flat plateau the laser's frequency is pinned. The flatter it is, the larger the stabilization coefficient K = ∂ωLD/∂ω, and the line narrows by Δν = K². The paper counts a laser as locked when Δν exceeds 1,000.
–
2 · The hidden knob
Feedback-phase dispersion
The spiral has a resonance every free spectral range (FSR), about 1.5 GHz. Light returning through each resonance arrives with its own feedback phase Ψ, which sets how strong and how lopsided that resonance's lock is. From one resonance to the next the phase advances by a fixed step, ΔΨ. The authors call it the feedback-phase dispersion and show that it decides whether locking can be endless.
ΔΨ is fixed by where the drop port sits along the resonator (τR, τL) and by the bus and drop waveguide lengths. These are centimetre-scale distances drawn by lithography: about 30 cm of free-space wavelength per 2π at a 1-GHz FSR. The phase shared by all resonances, Ψ0, depends on sub-micrometre details such as the laser–chip gap, and it drifts. In an endless design that drift only slides the whole landscape along.
–
Spacing alone is not the whole story. The laser favours its narrowest-linewidth states, and each lock is lopsided. With ΔΨ > 0 the locking regimes evolve during a current sweep so that a narrow-linewidth state is always available. With ΔΨ ≈ 0 or small negative values the best regimes bunch together, leaving stretches where only poor states, or the free-running one, remain (paper Fig. 2e–h). The presets at the top of the page are exactly these cases: same laser, same chip, only ΔΨ changes.
The two fabricated spirals (highlighted blue; drop and bus waveguides red). Their port placements differ by a few centimetres of path, enough to flip the sign of ΔΨ. Microscope images: Reichler et al. 2026, Fig. 3b,c (CC BY 4.0), cropped from the figure.
3 · Explore
Map the endless region
Each cell is a design: a mode spacing (FSR, rows) and a feedback-phase dispersion (columns). Click one to sweep the laser across ±8 GHz with the same simulation as the bench. Cyan means it stayed locked; ember means long free-running stretches. Then fill in the rest and compare with the paper's own map.
Click a cell to run it.
Precomputed cells: this page's simulator with the parameters of the authors' Fig. 2 scripts, three sweeps per cell at different collective phases, coloured by the worst of the three. Locked means a stabilization coefficient K > 30 (Δν > ~10³).
4 · Measured
What the chips did
An off-the-shelf DFB laser at 1,548 nm was butt-coupled to the silicon nitride chip and its current swept with no active control of current or phase. Everything in this section is measured data from the paper, re-plotted from the authors' open dataset.
Laser frequency (beat note against a reference laser) as the current is swept over more than two full feedback-phase periods. GHz relative to 193 THz, both axes decreasing as in the paper; faint lines mark resonances. Colour comes from the slope of the measured trace: flat = locked, sloped = free-running. Data: Reichler et al. 2026, Fig. 3j,k; Zenodo 10.5281/zenodo.17483072 (CC BY 4.0).
Quiet at every current
Frequency noise was recorded at 74 drive currents from 154 to 300 mA, in 2-mA steps, with nothing adjusted in between. The paper reports noise lowered by a factor of over 5,000 relative to the free-running DFB at every current, and intrinsic linewidths below 10 Hz. That is at least 10,000-fold narrower, close to the thermorefractive-noise limit of the resonator.
–
Tuned without a hop
The chip carries monolithic piezoelectric actuators that squeeze the resonator. Driven with a 10-kHz, 50-V triangle, the locked laser's frequency follows linearly over more than one FSR at every current step, without mode hops. Choose a current:
–
A version of the laser in a butterfly package drifted only about 40 MHz over 12 hours, with no mode hops (Supplementary Section VII). The laser delivers several milliwatts, comparable to state-of-the-art precision lasers.
5 · Why it matters
Hertz-level lasers that just switch on
Optical atomic clocks, frequency-modulated LiDAR, distributed fibre sensing and coherent communications all want ultralow-noise lasers. Endless locking turns self-injection locking from a delicate laboratory routine into a turnkey device that needs no control loop, which makes such lasers smaller, cheaper and easier to deploy. The authors note that the same design should carry over to visible and ultraviolet integrated platforms, to Fabry–Pérot laser diodes, and to bulk crystalline resonators.
Source
Mikael Reichler, Simone Bianconi, Yichi Zhang, Marco Liffredo, Luis Guillermo Villanueva & Tobias J. Kippenberg. Endlessly self-injection-locked photonic integrated lasers. Nature Photonics 20, 1146–1152 (2026). doi:10.1038/s41566-026-01985-1 · article page
Data and simulation code: Reichler, Bianconi, Zhang & Kippenberg, Zenodo, doi:10.5281/zenodo.17483072.
Figures, photographs and data are reproduced or adapted from the article and its dataset under the Creative Commons Attribution 4.0 licence (CC BY 4.0). Images are cropped and data re-plotted, with resampling where noted. The bench, the single-resonance curve, the phase wheel and the design map are simulations. They use a JavaScript port of the authors' published rate-equation model with the parameters of their Fig. 2 scripts. Changes from the original are a fixed-step integrator, a rotating frame and the Kerr term omitted (it is zero in the original scripts). They show the mechanism, not the measured device's exact numbers. The chip drawing is a schematic.
Topics in this iPaper
Physics
Narrow-linewidth integrated lasers are essential tools for optical atomic clocks, fibre sensing and other technologies.
Abstract, page 1146
Engineering
Here we demonstrate a photonic integrated turnkey self-injection-locked laser that eliminates these constraints
Abstract, page 1146
self injection locking
An effective way to reduce the laser linewidth is self-injection locking (SIL) in which optical feedback from a high-quality-factor (Q) cavity
Introduction, page 1146
integrated photonics
Recent advances in silicon nitride low-loss photonic integrated circuits allowed compact self-injection-locked semiconductor lasers to achieve exceptional coherence.
Abstract, page 1146
optical microresonators
a spiral microresonator fabricated on silica-cladded Si3N4
Results, Experimental demonstration of endless SIL, page 1150
narrow linewidth lasers
The photonic integrated laser exhibits persistent locking with intrinsic linewidths below 10 Hz at all drive currents
Abstract, page 1146
laser frequency noise
demonstrate a reduction in laser frequency noise by a factor of over 5,000 relative to the free-running DFB for all measured drive currents
Results, Experimental demonstration of endless SIL, page 1150
piezoelectric tuning
during mode-hop-free 1.5-GHz frequency chirps enabled by monolithically integrated piezoelectric actuators
Abstract, page 1146